V-COIL Inserting Tool (Drive connector 1/4") UNC 1/4

• For wire thread inserts size UNC 1/4
• Ideal for repair, mechanical engineering, automotive, and metalworking
• Suitable for aluminium, steel, cast iron and technical plastics
• Compatible with V-COIL and equivalent systems

Installation steps:

• Drill the core hole, cut the thread and clean thoroughly.
• Fully screw the insert onto the inserting tool.
• Align straight with the thread entrance.
• Install the insert carefully and pull off the tool.

1. Prepare the core hole: Drill, cut thread, clean.
2. Mount the insert: Place the wire thread insert onto the tool.
3. Align: Position vertically at the thread entrance.
4. Install: Turn evenly without tilting.
5. Check: Ensure correct seating and remove tool.

• Size: UNC 1/4
• Drive Connector: 1/4" square
• Material: High-strength precision steel
• Compatible with: V-COIL & equivalent systems
• Article Number: 08195
• EAN: 4022835081951

1. Which thread type is this tool suitable for?

This tool is specifically designed for wire thread inserts size UNC 1/4.

2. Can I use the tool with a cordless screwdriver?

Yes, but only at low speed. For maximum precision, a ratchet or torque wrench is recommended.

3. What if the insert is difficult to screw onto the tool?

Usually the wire insert is slightly deformed. Replace it with a new one.

4. How do I know if the insert is correctly positioned?

The insert must engage cleanly with the driver and screw on evenly without tilting.

5. Is the tool suitable for deep installation areas?

Yes, as long as the wire thread insert has the appropriate length.

6. Can I use this UNC 1/4 tool with metric inserts?

No, UNC and metric inserts differ in pitch and geometry.

7. How should I maintain the tool?

Clean after use, lightly oil, and store in a dry place to prevent corrosion.

8. What if the insert is installed crooked?

Remove the tool, discard the insert, and restart with proper thread preparation.

• 1× V-COIL Inserting Tool, 1/4", UNC 1/4 (Art.-No. 08195)