Die Stock steel 160 x 25 mm

• holding round dies for external thread cutting or external thread reworking
• manual use where the die outside diameter matches the die stock size
• alignment control at the start of the external thread
• maintenance, repair, and assembly tasks that require hand driven round dies

Note Check the die outside diameter, clamp screw position, and available swing radius before use.

• DIN 225 (DIN EN 22568) reference supports selection by established holder dimensions
• steel version construction is stated in the product data and supports workshop handling
• stated working range 160 x 25 mm gives a factual basis for size matching
• clamp screws hold the round die in the central body when the die dimensions match

• The accessory works only when the tool dimensions match; choose a different holder size in the Threading tools category if the fit is not correct.

1. Compare the round die outside diameter with the die stock size.
2. Open the clamp screws enough to insert the die without tilting it.
3. Place the die centrally in the holder body.
4. Tighten the clamp screws evenly so the die sits securely.
5. Align the die stock square to the workpiece before applying torque.
6. Remove the die after use and clean the holder contact surfaces.

• 1 piece Die Stock steel 160 x 25 mm

• Product type: die stock
• Standard: DIN 225 (DIN EN 22568)
• Material: steel version
• Size: 160 x 25
• Working range: 160 x 25 mm
• Length L1: 996 mm
• Packaging unit: 1

Question: What is this die stock used for?

Answer: It holds round dies for manual external thread cutting or careful external thread reworking.

Question: How do you select the correct die stock?

Answer: Select it by the round die outside diameter and the available working space around the workpiece.

Question: Does the die stock cut the thread itself?

Answer: No. The round die cuts the thread, while the die stock clamps and drives the die.

Question: What should be checked before use?

Answer: Check die diameter, clamp screw position, central seating, and alignment to the workpiece axis.

Question: Can this holder be used in maintenance work?

Answer: Yes, it is useful when a matching round die is used for repair, assembly, or field service tasks.

Question: Where can you find the holder and threading tool catalog?

Answer: Use the VD 23 catalog as PDF.