V-COIL Inserting Tool (Drive connector 1/4") UNC 5/16

• For wire thread inserts with size UNC 5/16
• Ideal for mechanical engineering, metalworking, automotive, maintenance and repair
• Suitable for aluminium, steel, cast iron and technical plastics
• Compatible with V-COIL and equivalent thread repair systems

Follow these steps when installing inserts:

• Drill the core hole, cut the special thread and clean thoroughly.
• Screw the insert completely onto the inserting tool.
• Position the tool straight at the thread entrance.
• Install the wire thread insert with controlled torque and remove the tool afterwards.

1. Prepare the core hole: Drill, cut and clean.
2. Attach the insert: Screw the wire insert onto the tool.
3. Align correctly: Position straight and without tilting.
4. Install the insert: Rotate smoothly by hand or with a tool.
5. Finish: Check the fit and remove the inserting tool.

• Thread Size: UNC 5/16
• Drive Connector: 1/4" square
• Material: High-strength precision steel
• Compatible with: V-COIL & equivalent systems
• Article Number: 08196
• EAN: 4022835081968

1. What is this tool designed for?

This tool is specifically designed for installing UNC 5/16 wire thread inserts with maximum precision.

2. Can I use a cordless drill with this tool?

Yes, but use a low speed setting. For the best control, a ratchet or torque wrench is recommended.

3. Why does the insert not screw on smoothly?

In most cases the insert may be slightly bent. Replace it with a new one to avoid installation issues.

4. How do I ensure the insert is aligned correctly?

Make sure you position the tool straight and begin with slow, even pressure to avoid cross-threading.

5. Is the tool suitable for tight installation spaces?

Yes, its compact geometry makes it suitable even in limited-access areas.

6. How durable is the inserting tool?

The tool is manufactured from hardened precision steel, ensuring long-lasting dimensional stability.

7. Do I need to perform maintenance on the tool?

Simply clean it after use and apply a light oil film to prevent corrosion.

8. Are inserts from other brands compatible?

Yes, as long as the inserts follow the same UNC 5/16 specification and design.

• 1× V-COIL Inserting Tool, 1/4", UNC 5/16 (Art. No. 08196)