Jaws and Springs for tap holder with ratchet (10 pieces)

• Use for clamping, guiding, or servicing hand operated threading tools in repair, maintenance, and workshop environments.
• Select by holder number, product type, operating direction, and the equipment already used at the workstation.
• Check the holder, jaws, springs, and handle movement before the tool is loaded by hand torque.
• Do not infer thread size compatibility from this accessory description when the product data does not state a concrete size range.

Note Confirm mechanical fit with the existing holder or tool before use. Replace worn clamping parts before they can damage the tool shank or reduce control.

• Ratchet operation supports controlled right hand and left hand manual movement when the holder is matched to the tool.
• A defined holder number helps separate similar workshop accessories during selection and storage.
• Replaceable jaws and springs support maintenance of the holder instead of replacing the complete workstation setup.
• The accessory supports stable hand operation when the clamping surfaces are clean and mechanically intact.

• Compatibility must be checked against the existing holder or tool because the product data does not state every matching interface.
• Worn jaws, springs, or ratchet parts can reduce clamping security and should be inspected before repeated use.

1. Identify the holder number or replacement part requirement on the existing workshop tool.
2. Compare the product name with the holder or accessory marking before installation.
3. Inspect the contact surfaces and remove oil, chips, or debris from the clamping area.
4. Install the accessory or holder component without forcing the mechanism.
5. Check that the ratchet or clamping movement operates smoothly in the required direction.
6. Insert the threading tool only after the holder or replacement parts sit correctly.
7. Apply hand torque gradually and stop when the tool shifts or the holder slips.
8. Clean the holder after use and store the accessory in a dry workshop location.

• 10 pieces Jaws and Springs for tap holder with ratchet (10 pieces)

• Product type: Replacement jaws and springs
• Scope indicator: 10 pieces

How do you select this accessory correctly?

Match the holder number, product type, and existing tool interface before use, because the product data does not state a universal compatibility range.

Can you use this accessory with any tap or die?

No. Use it only when the holder, shank, jaw set, or tool interface is confirmed to match the accessory.

What should you inspect before use?

Check the ratchet movement, jaws, springs, clamping surfaces, and handle condition before applying hand torque.

What causes poor clamping in a threading holder?

Poor clamping usually comes from worn jaws, dirt in the clamping area, damaged springs, or a tool shank that does not match the holder.

How should this accessory be stored?

Store it clean and dry, with moving parts protected from chips and corrosion.

Where can you find more VÖLKEL threading tool information for selection and application?

Use the catalog for product family context and additional selection data: VD 23 catalog as PDF