Round Die DIN 223 (DIN EN 22568) HSSE VAP - M 9 x 0.5

• alloyed tough materials up to 1200 N/mm²
• stainless steels
• cast aluminium
• spheroidal graphite cast iron
• also for general-purpose use
• for manual and machine use

Note Match the die to the external thread data and keep holder, lubrication, and alignment controlled during use.

• high edge retention
• light cutting action
• free chip flow towards the front
• reduced clogging of chip holes
• vaporized surface supporting cutting oil adhesion

• The VX execution still needs correct lubrication and alignment, so do not compensate a poor setup with higher torque.

1. Confirm that the required external thread is M 9 x 0.5 before selecting the die.
2. Choose a holder that matches the die shape and size.
3. Prepare the bolt, stud, or shaft with a clean start chamfer.
4. Apply cutting fluid that fits the workpiece material and process.
5. Place the die square to the workpiece axis before turning.
6. Cut or rework the thread with controlled pressure and steady alignment.
7. Reverse carefully when needed to clear chips from the cutting area.
8. Clean the finished external thread before assembly.
9. Check the thread with a matching nut, gauge, or inspection process where required.

• 1 piece Round Die DIN 223 (DIN EN 22568) HSSE VAP - M 9 x 0.5

• Product type: round die HSSE VAP
• Thread system: M
• Thread designation: M 9 x 0.5
• Standard: DIN 223
• Material: HSSE
• Surface or coating: VAP
• Die form: round die
• Thread target: external threads
• Direction: RH
• Package quantity: 1

What thread does this die cut?

It cuts or reworks an external thread for M 9 x 0.5 when the workpiece and drawing match the product data.

Is this tool for internal or external threads?

The die is for external threads, while internal threads require a matching tap for M 9 x 0.5.

Which holder do you need?

Use a suitable round-die holder that supports the die form and keeps the tool square to the workpiece axis.

What does HSSE VAP mean for selection?

HSSE VAP is stated in the product data and indicates a tougher cutting material with vaporized surface treatment for cutting oil adhesion and friction behavior.

Can it be used as a gauge?

No, the die is a cutting or reworking tool and final inspection should use the required gauge or quality process.

Where can you find round die information?

Additional round die information is available here: Technical information round dies as PDF

What prevents damage during reworking?

A clean start, square alignment, and low controlled pressure prevent the die from crossing or tearing the first threads.

Where can you find the threading tools catalog?

You can find the threading tools catalog here: VD 23 catalog as PDF